[App_rpt-users] Female voice announce levels
dacndar at yahoo.com
Fri Dec 10 11:38:00 EST 2010
If you read the instructions on the support pages for creating custom voice
announcements with the Audacity program, you'll see that you are instructed
to set the final level of the voice file to -6 db before saving it. I assume
that this is based on 5Khz deviation radios. The voice announcements are
mixed with all the other levels through the sound card chip and I suspect
that the only way to adjust the voice without affecting the other levels is
to re -record the sound files with a lower level specifically for use with
narrow band 2.5 Khz radios.
On Fri, Dec 10, 2010 at 7:09 AM, Ken Leisten <dacndar at gmail.com> wrote:
> Yes, all radio levels were adjusted properly.
> ----- "Tim Sawyer" <tim.sawyer at mac.com> wrote:
> > From: "Tim Sawyer" <tim.sawyer at mac.com>
> > To: "Ken Leisten" <dacndar at gmail.com>
> > Cc: "app rpt-users" <app_rpt-users at qrvc.com>
> > Sent: Friday, December 10, 2010 5:47:28 AM GMT -08:00 US/Canada Pacific
> > Subject: Re: [App_rpt-users] Female voice announce levels
> > Did you try the transmit audio adjustment shown here?
> > http://app-rpt.qrvc.com/node/28
> > Basically you have the controller send a 1 Khz tone and adjust your tx
> > for 3 Khz dev. The document is incorrect however... the command in
> > default configurations is *989 (not *99). And use *989 to turn the
> > tone off (not #)... it's a toggle
> > ---
> > TIS
> > On Dec 8, 2010, at 12:59 PM, Ken Leisten wrote:
> > All,
> > What is the name and location of the parameter that controls female
> > voice volume? It is too loud on my system.
> > Thanks,
> > Ken
> > K6DND
> > _______________________________________________
> > App_rpt-users mailing list
> > App_rpt-users at qrvc.com
> > http://qrvc.com/mailman/listinfo/app_rpt-users
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the App_rpt-users