[App_rpt-users] cor active PL logic
monty at ke7jvx.com
Sun Jan 1 23:19:11 EST 2012
That command list was pulled from the source app_rpt.c and the asterisks
are to comment those lines out. To excute those commands you will need to
create a function. I put them under [functions] in
/etc/asterisk/rpt.conf. For example:
900 = cop,58 ;Tx CTCSS On Input only Enable
901 = cop,59 ;Tx CTCSS On Input only Disable
A *900 will execute TX CTCSS Enable, *901 will execute TX CTCSS Disable.
Also Allstarnode.com is not maintained by the developers of app_rpt, it is
a third party site. The current site for configuration information is
http://ohnosec.org/drupal. The variable you are looking for is documented
On Sun, Jan 1, 2012 at 2:04 AM, Fredric Moses <fred at moses.bz> wrote:
> I am working on getting a logic output to run my PL encoder for COR active
> PL on the main repeater port. using a variable i was able to get it to
> work fine with local RX audio. When a signal is present I have a gpio pin
> going low.. when not present going back high.. but can not find a
> variable to watch for IP links coming in. Is there one? Is there something
> I can watch so that I can make the logic pin swing..?
> Some google foo found these commands
> * 56 - Rx CTCSS Enable
> * 57 - Rx CTCSS Disable
> * 58 - Tx CTCSS On Input only Enable
> * 59 - Tx CTCSS On Input only Disable
> The only mention I see of TX PL is with use of a USB radio interface.
> Will *58 follow the tx pl settings set in usbradio if I had a USB radio
> device vs using one of the LOX ports for the main repeater..
> Fredric Moses - W8FSM - WQOG498
> fred at moses.bz
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the App_rpt-users