[App_rpt-users] cor active PL logic

Fredric Moses fred at moses.bz
Sun Jan 1 23:22:34 EST 2012


Thanks for the reply monty..  But when I enable this is it controlling a logic gpio. or is it controlling the PL freq generated into the audio audio out...  I am using the beagleboard/lox combo which i was under the impression needed external decode and encode of pl's.. Unlike the usb interface from dmkeng...

--
Fredric Moses - W8FSM - WQOG498
fred at moses.bz




On Jan 1, 2012, at 11:19 PM, Monty wrote:

> Hi Fredric,
> That command list was pulled from the source app_rpt.c and the asterisks are to comment those lines out.  To excute those commands you will need to create a function.  I put them under [functions] in /etc/asterisk/rpt.conf.  For example:
> 
> [functions]
> 900 = cop,58        ;Tx CTCSS On Input only Enable
> 901 = cop,59        ;Tx CTCSS On Input only Disable
> 
> A *900 will execute TX CTCSS Enable, *901 will execute TX CTCSS Disable.
> 
> Also Allstarnode.com is not maintained by the developers of app_rpt, it is a third party site.  The current site for configuration information is http://ohnosec.org/drupal.  The variable you are looking for is documented at http://ohnosec.org/drupal/node/176.
> 
> 
> Monty
> 
> 
> On Sun, Jan 1, 2012 at 2:04 AM, Fredric Moses <fred at moses.bz> wrote:
> I am working on getting a logic output to run my PL encoder for COR active PL on the main repeater port.  using a variable i was able to get it to work fine with local RX audio. When a signal is present I have a gpio pin going low.. when not present going back high..   but can not find a variable to watch for IP links coming in. Is there one?  Is there something I can watch so that I can make the logic pin swing..?
> 
> Some google foo found these commands
> * 56 - Rx CTCSS Enable
> * 57 - Rx CTCSS Disable
> * 58 - Tx CTCSS On Input only Enable
> * 59 - Tx CTCSS On Input only Disable
> http://allstarnode.com/viewtopic.php?f=5&t=8
> 
> The only mention I see of TX PL is with use of a USB radio interface.  Will *58 follow the tx pl settings set in usbradio if I had a USB radio device vs using one of the LOX ports for the main repeater..
> 
> --
> Fredric Moses - W8FSM - WQOG498
> fred at moses.bz
> 
> 
> 
> 
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
> 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.allstarlink.org/pipermail/app_rpt-users/attachments/20120101/c4136683/attachment.html>


More information about the App_rpt-users mailing list