[App_rpt-users] [Fwd: Re: Frequency Agile Remote - Continued]
wb3awj at comcast.net
Sat Jul 27 09:07:42 EDT 2013
Sorry, didn't notice that was off list.....
Robert A. Poff
1983 Hunter 34
Havre de Grace, MD.
WB3AWJ - Allstar 27784
Powered by Linux
-------- Forwarded Message --------
From: Tim Sawyer <tim.sawyer at me.com>
To: Robert A. Poff WB3AWJ <wb3awj at comcast.net>
Subject: Re: [App_rpt-users] Frequency Agile Remote - Continued
Date: Fri, 26 Jul 2013 22:31:53 -0700
Here's my Xcat config... if it helps any.
 ; Change this to your assigned node number
rxchannel = Simpleusb/usb ; Rx audio/signalling channel
remote = xcat
civaddr = 32
functions = functions-remote
lconn = PP3=1
ldisc = PP3=0
memory = memory ; Section to hold memory entries (optional)
; remote=ft897 for Yaesu FT-897 or
; remote=rbi for Doug Hall RBI1
; remote=kenwood for Kenwood mobiles such as the TMG707A
; remote=ic706 for the Icom IC-706
ioport = /dev/ttyS0 ; Specify port for serial port (optional)
iospeed = 19200
dusbabek = yes
;iobase = 0x378 ; Specify IO port for parallel port (optional)
authlevel = 2 ; Remote base authentication level
;; authlevel = 0 : Anyone can use it
;; authlevel = 1 : Requires log in, Waits for Tx key to ask for it
;; authlevel = 2 : Requires log in, asks for it automously
;mars = 0 ; set=1 for IC-706 w/MARS mods (optional)
remote_inact_timeout=1800 ; Inactivity timer for remote base
nodes only (set to 0 to disable).
remote_timeout=5400 ; Session time out for remote base.
(set to 0 to disable)
;remote_timeout=120 ; Session time out for remote base.
(set to 0 to disable)
On Jul 26, 2013, at 9:21 PM, Robert A. Poff WB3AWJ <wb3awj at comcast.net>
> Still can't set the frequency on an XCAT.
> I've done a complete clean install.
> By running Asterisk in the foreground and turning up the debug levels,
> I see the CIV command being
> sent to the XCAT is
> FE FE 20 E0 08 01 FD
> Which if I'm right is trying to retrieve memory #1 from the radio. Not
> write to the VFO (function 05 instead of 08).
> In rpt.conf I have the remote defined as xcat (remote = xcat).
> So what gives?
> Again, this was working before I updated from a version of app_rpt
> from about a year ago, to current.
> Robert A. Poff
> Loganville, PA.
> "Lieutenant, target the offending power boat and launch photon
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the App_rpt-users