[App_rpt-users] control of the tx tone

REDBUTTON_CTRL jrorke at cogeco.ca
Sat May 4 08:24:09 EDT 2013


You can set up the dtmf commands in rpt .conf like this:

882=cop,58                ; talk through tone
883=cop,59                ; normal ctcss


Then define a macro that calls *882 as above.

[macros]

300 = *882                ; go to tone talk through mode

Set up a startup macro in the node stanza to execute the talk through 
ctcss when Asterisk restarts.

startup_macro=*5300           ; enable talk through tone

This assumes your macro prefix is defined as 5.

And yes it does work every time Asterisk is started.

Jon VA3RQ



On 5/3/2013 9:06 PM, pete M wrote:
> Bingo! Thanks Scott!
>
>
> Envoyé de mon iPad
>
> Le 3 May 2013 à 21:01, "Scott Weis"<kb2ear at kb2ear.net>  a écrit :
>
>> Yes there is put:
>>
>> itxctcss=1
>>
>> in the node stanza.
>>
>> -----Original Message-----
>> From: app_rpt-users-bounces at ohnosec.org
>> [mailto:app_rpt-users-bounces at ohnosec.org] On Behalf Of Pierre Martel
>> Sent: Friday, May 03, 2013 8:26 PM
>> To: Matt Roberts
>> Cc: APP RPT
>> Subject: Re: [App_rpt-users] control of the tx tone
>>
>> Thanks matt,
>>
>> This would work, but is there a way to make it permanent?
>>
>> like in rpt.conf or such?
>>
>>
>> -----Message d'origine-----
>> From: Matt Roberts
>> Sent: Friday, May 03, 2013 7:56 PM
>> To: Pierre Martel
>> Cc: APP RPT
>> Subject: Re: [App_rpt-users] control of the tx tone
>>
>>
>> On May 3, 2013, at 7:35 PM, Pierre Martel<petem001 at hotmail.com>  wrote:
>>
>>> All is working ok, but I have a few friend that use my repeater with some
>>> cross band repeater radio. And they have difficulty cutting in cause they
>>> have to wait after the tail and ct. before there cross band repeat radio
>>> give them the chance to tx back at the repeater.
>>>
>>> On my old rc-210 we were able to stop encoding the ctcss tone while the
>>> courtesy tone and tail of the repeater..So they were runnign ther xband
>>> radio on tone squelch on rx and the tx on there side was fast and sharp.
>>>
>>> Is there  a way to do the same with app_rpt?
>>> Yes! Take a look at cop commands 58 and 59.
>> *  58 - Tx CTCSS On Input only Enable
>> *  59 - Tx CTCSS On Input only Disable
>>
>> I have those commands defined so I can turn on and off using DTMF.
>>
>>
>> Matt Roberts
>> n9gmr at me.com
>> Call Sign N9GMR
>> Allstar 28142
>> EchoLink 640860
>>
>> _______________________________________________
>> App_rpt-users mailing list
>> App_rpt-users at ohnosec.org
>> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users
>>
>>
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at ohnosec.org
> http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users



More information about the App_rpt-users mailing list