[App_rpt-users] Does anyone have a working circuit diagram for Baofeng/Kenwood to URIx?

Takeshi Morgan cypher at arcticwerks.com
Wed Jun 11 16:20:20 EDT 2014


Which Baofeng radio? 

I have used the Baofeng UV-5R and it works by using the the Mic jacks for rx/tx and PTT for the COS you have to solder to pin 2 of the audio chip which is pretty tiny but can be done. 

TJ

----- Original Message -----
From: "Scott Weis" <kb2ear at kb2ear.net>
To: "Steven Donegan" <steve at donegan.org>, "'App RPT Users'" <app_rpt-users at ohnosec.org>
Sent: Wednesday, June 11, 2014 11:40:32 AM
Subject: Re: [App_rpt-users] Does anyone have a working circuit diagram	for	Baofeng/Kenwood to URIx?





I doubt you will find much help anywhere. Baofeng radios lack COR and discriminator output so they would not be suitable for use with allstar. The only portable I know of that works is the Kenwood F6 with it mic/speaker port set for packet mode. But the duty cycle required for allstar or any repeater/remote base is fairly high and portables are not suitable for long term use. 





From: app_rpt-users-bounces at ohnosec.org [mailto:app_rpt-users-bounces at ohnosec.org] On Behalf Of Steven Donegan 
Sent: Wednesday, June 11, 2014 3:21 PM 
To: 'App RPT Users' 
Subject: [App_rpt-users] Does anyone have a working circuit diagram for Baofeng/Kenwood to URIx? 





I am looking for a circuit diagram so I can fabricate a cable to connect a URIx to a Baofeng (or pair of Baofeng's) suitable for use with ACID/Allstar. Any assistance would be useful. I have not found anything on the web thus far... 





____________ 
Steven Donegan 
KK6IVC 
SSCC/NORC Life Member, Car #86 
www.sscc.us 
_______________________________________________
App_rpt-users mailing list
App_rpt-users at ohnosec.org
http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users

To unsubscribe from this list please visit http://ohnosec.org/cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of the page. Enter your email address and press the "Unsubscribe or edit options button"
You do not need a password to unsubscribe, you can do it via email confirmation. If you have trouble unsubscribing, please send a message to the list detailing the problem. 



More information about the App_rpt-users mailing list