[App_rpt-users] Correct Wiring For The URIx Diagnostic Dongle

John C. Westmoreland, P.E. john at westmorelandengineering.com
Fri Aug 14 01:51:43 EDT 2015


Hello Again,

To get correct results - doesn't it make more sense to wire up this:
http://www.dmkeng.com/images/URIx_TEST_FIXTURE.pdf

>From the above - how does AIN (pin 24) work?

73's,
John
AJ6BC


On Wed, Aug 12, 2015 at 10:39 PM, John C. Westmoreland, P.E. <
john at westmorelandengineering.com> wrote:

> Hello All,
>
> Here is the wiring instructions from the FAQ:
>
> Pin 1 to Pin 7
> Pin 2 to Pin 3
> Pin 4 to Pin 8
> *Pin 23 to Pin 24*
> 10K Resistor between Pins 21 and 22
> 10K Resistor between Pins 21 and *23*
> For URIx (CM119) only, also include the following connections:
> Pin 5 to Pin 10
> Pin 6 to Pin 11
>
> From uridiag:
>
> Enter your selection:c
> Special Test Cable Pinout:
>
> 25 pin D-shell connector
>   Pin 1 to Pin 7
>   Pin 2 to Pin 3
>   Pin 4 to Pin 8
>  * Pin 11 to Pin 24*
>   10K Resistor between Pins 21 & 22
>   10K Resistor between Pins 21 & 23
>   For URIx (CM119), also include the following:
>   Pin 5 to Pin 10
>   Pin 6 to Pin* 11*
>   Do *NOT* include these for the standard URI!!
>
> So, which one of these do I use?
>
> 73's,
> John
> AJ6BC
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.allstarlink.org/pipermail/app_rpt-users/attachments/20150813/2fde842b/attachment.html>


More information about the App_rpt-users mailing list