[App_rpt-users] RTCM Inbound (Eth Rx) packet out of bounds

Lee Woldanski ve7fet at tparc.org
Sat Sep 23 21:27:13 EDT 2017


Have you quantified your network parameters and set your buffers using the
tuning procedure?

http://docs.allstarlink.org/drupal/node/108

Where is your asterisk/allstar server, in relation to your MASTER site? Per
the votersystem.pdf:

There must be a VOTER (RTCM) board on the same LAN (very low latency) as
the Asterisk server
implementing the “master site”, which acts as the Master Timing source.
This allows chan_voter to
have a consistent, reliable, accurate timing source with which the timing
information from all other
inbound packets are compared and appropriately processed, and from which to
generate accurate
timing information for time-consistent transmission purposes.


Cheers!


Lee

On Sat, Sep 23, 2017 at 5:41 PM, Hayden Honeywood <haydenph91 at gmail.com>
wrote:

> More testing last night and today.
>
> I set the TX Buffer to 1200 last night, rebooted both RTCM units and it
> was working fine last night.
>
> Switched off one of the sites (at home) overnight. Came back this morning,
> powered up and getting the packet out of bounds issues again. Changed up to
> 1600 and rebooted both units, worked again. buflen set to 250.
>
> Is it just a matter of increasing these up and up until it's stable even
> after a power reset?
>
> I've been swapping out ethernet cables too just checking to make sure that
> is not the issue... Could still be a hardware problem. Next thing to change
> is the port from 667 to make sure there is no limiting down at the ISP
> level.
>
> _______________________________________________
> App_rpt-users mailing list
> App_rpt-users at lists.allstarlink.org
> http://lists.allstarlink.org/cgi-bin/mailman/listinfo/app_rpt-users
>
> To unsubscribe from this list please visit http://lists.allstarlink.org/
> cgi-bin/mailman/listinfo/app_rpt-users and scroll down to the bottom of
> the page. Enter your email address and press the "Unsubscribe or edit
> options button"
> You do not need a password to unsubscribe, you can do it via email
> confirmation. If you have trouble unsubscribing, please send a message to
> the list detailing the problem.
>



-- 
Lee Woldanski, AScT
VE7FET
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.allstarlink.org/pipermail/app_rpt-users/attachments/20170923/902d3bca/attachment.html>


More information about the App_rpt-users mailing list